How To Remove Rubber Rug Backing From Wood Floor

Always makes sure your wooden floor is completely dry before laying down a non skid rug.

How to remove rubber rug backing from wood floor.

Spray the area where the latex is present using a spray lubricant. You can dig into the foam without fear because the plastic isn t hard enough to scratch the floor finish. You can work in patches going back and forth. The denatured alcohol did the trick of removing the stuck on rug backing that was left behind after the removal of the seagrass rug and it didn t damage the wood flooring.

Picture the path you walk around and around your bed when you re making it up in the morning that s where the rubber backing stuff stuck to my hardwood flooring. Scrape off as much of the carpet backing from the floor as you can using a plastic paint scraper. Removing the latex backing that is stuck to the wood floor scraper. Use a plastic scraper to remove as much latex as possible without vigorously scraping to avoid gouging your floors.

Allow it to soak into the dried latex for at least five minutes. There are a few shadows where the backing was stuck but i m hoping those will fade out with time at least that s what my hardwood flooring company thinks they will do. Substitute mineral oil or olive oil for the baby oil to remove sticky residue. Apply a solvent to the latex rubber to soften it.

You still have to scrape but it is much easier. A solution of warm water and a standard floor cleaner works or you can make your own solution by adding an ounce of dish detergent and a cup of vinegar to a gallon of warm water. The heat and dampness soften the residue making it easier to remove. As mentioned the only place the rug s backing deteriorated and stuck to the hardwood flooring is in the immediate path around the bed.

I had the same thing happen to me i used water. If a thick layer of latex is present on the floor allow it to. Soak a clean cloth in soapy water and lay it over the sticky residue for a few minutes.