Make sure your routing table is clear of sawdust and other debris.
How to tongue and groove boards for flooring.
The birch was felled on the property and milled on a woodmizer lt15 sawm.
Steve and hannah are making tongue and groove flooring for a bathroom remodel.
Any rubbish under the wood can cause errors in your cuts.
Not only will the shaper be able to handle the quantity of boards setting it up is simple.
The traditional method of nailing hardwood tongue and groove flooring is to drive nails at an angle through the tongue of a plank and into the subfloor below but this is time consuming and can.
Installing floating tongue and groove flooring can provide you with a beautiful floor in any area of the house.
Tongue and groove joints can easily be made with a router when using the right bits on a proper router table.
In an ideal world without these restrictions the best method in cutting tongue and groove joints for floor panels is through the shaper.
Both the tongue and groove is passed through just once and gives it a beautiful and strong factory like fit.
Begin laying flooring from the wall measure one board width and snap a chalk line.
Using a floating installation will also allow you to easily install the job yourself.