How To Remove Floor Trim Boards

Carefully pry outward letting the finish nails slide through the holes in the trim or out of the wall support as applicable.

How to remove floor trim boards.

Slide a flexible 3 in. Typically tilting the boards back and forth from 30 to 45 degrees will help them come apart. With the knife in place wedge in a pry bar and pry the trim out an inch. When you reach the end of the first row of flooring move to the next row and continue until all of the material is removed.

Removing the pieces should seem easier as you move along and get the feel of the angle at which the planks disengage. Position a crowbar over the towel. Start at an end begin prying from either end of the trim slipping the edge of the pry bar under the trim and prying against the wood wedge or block. Color trends painting suggests you mix warm water with a mild soap and begin scrubbing off the paint with a dampened rag.

Pull back sharply on the handle to wrench the board from its place. Gently work a 6 inch metal putty knife behind the baseboard and wiggle the tool while pulling mostly forward to loosen the pins or finishing nails holding the trim on the wall. Run a bead of paintable caulking along the top of the molding filling the gap between the wood and the wall. How to remove water based paint from wood floors with soap and water for dried water based paint start with good old soap and water.

Prepare the floor trim for removal and extraction with help. Wedge the tip of the pry bar underneath a section of flooring. Use your finger to work the caulk into the gap and a damp towel to remove any excess. Start at one end of.

As you use the crowbar to pry the t molding away from the floor the towel protects the floor from the metal of the crowbar. Use a pry bar to pull up the boards. If you re planning on replacing carpet or flooring you ll need to replace the floor trim first. Work your way down.

If it seems like the trim is about to crack insert a second putty knife between the pry bar and the trim. Lay a towel on the floor next to the portion of t molding you ll be working with. Assuming you ve sawed the boards into small enough sections they should pop right out. The paint should loosen allowing you to wipe it away with a dry rag.