Pry off the road barrier beneath the mobile home using a flat head screwdriver to remove staples a phillips screwdriver to remove screws and a pry bar to remove nails.
How to re insulate floor belly of older mobile home.
Add insulation up in the belly or attach insulation directly to the polyethylene.
When attaching insulation to the polyethylene use insulation with a paper kraft backing and attach with silicone.
Foam is used for new roof overs and has proven to be a good product to insulate and act as a belly board for mobile homes.
Loose fill or blown in.
You can see how one industrious couple used foam board to insulate under their mobile home here.
Fill the holes with insulation stuffing or wood cutouts to seal the holes.
If there is existing insulation it must be removed.
Secure polyethylene up to the belly using flex mend tape on all sides.
Remove any nests or debris handing from the underside of the floor.
This is a repair to a mobile home that had the belly torn open and the insulation had fallen out.
Any damage should be repaired before installing the insulation.
When someone brings up insulation most people only think of fiberglass rolls or insulating foams in large quantities covering an entire area.
Overlap the seams of the vapor barrier by 6 inches and secure the seams with.
Inspect the underside of the mobile home for damage holes or older insulation or plastic.
The underside of the mobile home should be inspected for damage on the flooring such as holes and or water build up.
This easy repair was used in two places on the mobile one.
Insulate existing concrete floors 1 cover the entire floor with a vapor barrier such as 6 mm polyethylene sheeting.
Mobile home insulation is one of the home improvement areas that is the most oversimplified.
Blowing insulation into the belly of your mobile home as we shared in our complete mobile home insulation guide blowing insulation into the belly and the ceiling of a mobile home is the most recommended method to insulate under a mobile home.