How To Place The Cutting Mat On Silhouttee

I just used it the same as a mat without the markings.

How to place the cutting mat on silhouttee.

Make sure to place the vinyl on the cutting mat with the shiny side down. These are perfect for scraps and pieces of vinyl you just can t waste. Yes i d love to say 20. When loading a cutting mat into your silhouette align the mat with the white rollers.

To use a 12 x24 mat in silhouette studio you will want to open your page setup panel on the left side of your screen after loading your design. This is especially important if your blade is not new. Select load cut mat from the display. This will put the adhesive side or the back side of the htv up which is why you are cutting in reverse.

I heard of some crafters that have place a note on the inside of the lid of their machine as a reminder. Make sure the arrow on the top of the mat is pointing into the machine. To load the cutting mat into the silhouette machine. Start by gently positioning the top edge of the silhouette cutting mat along the white rollers.

Overview of the s. Your machine will roll your mat into the cutting area. My silhouette 3 is still cutting in the wrong place up on the mat at the top left even though it is set for the 12 12 cutting mat in the silhouette studio. Prepare your mat in silhouette studio.

Use the blue line on the left hand side of your machine as a guide to align your mat. Place the htv onto the silhouette cutting mat with with the shiny side carrier sheet of the htv down. I could easily put this right on top of my silhouette mat and use a sharpie to mark the lines. It cut in the right place one time and then reverted back to cutting in the wrong place.

First one i used as a silhouette cameo cutting mat. The left edge of the mat should be aligned with the line and two arrows. This introductory video shows users how to load material with and without a cutting mat into the silhouette cameo. Put blade in straight there is a right way to put in the blade and according to silhouette tech gurus you should always have the fin on the blade pointing directly outward toward you if you have issues cutting and call or email the helpline this will be one of the first questions they ask you so it is good to keep in mind and make sure you have it in it s optimum position.

Place your material on your mat to correspond with the display in silhouette studio before cutting. I ve found that the default setting is for a newer blade.