How To Mount A Pedestal Sink To The Floor

Distance from the floor or wall to where the drain enters the wall or floor distance between the floor and the water supply pipes.

How to mount a pedestal sink to the floor.

More often than not the exisiting waste pipe is too low to install the trap which fits inside the pedestal richard says. The sink is mounted to the wall and also rests on the pedestal stand. The pedestal sink base is only a secondary support. The plumbing fits inside the pedestal which is secured to the floor.

Once the plumbing part of the installation is taken care of it s time to mount the sink to the pedestal. Set the sink on top of the pedestal then slide the sink close enough to the wall so. The pedestal s primary function is to hold the plumbing. Consider this a supplemental video to all the professional plumber videos that are available in which they don t really tell you everything to think about be.

Pedestal sinks come in two pieces the stand pedestal and the sink itself. Simply add a lag screw and then snug it down with a ratchet. Depending on how the pipes in your bathroom are set up it may be necessary to contact a plumber to run the water and drain lines for your pedestal sink. The sink bowl and the stand.

The pedestal sink must be mounted to the floor for stability. First choose your sink thenhire a plumber to rough in a new waste pipe. Most pedestal sink basins hang from a bracket attached to a mounting brace or framing in the wall. The pedestal base is set into place and aligned with the mounting holes drilled in the floor when applicable.

Before you decide to purchase here are some things to think about. Be sure not to over tighten. Pedestal sinks come in two separate pieces. Sit on the floor with the sketch in hand and visualize how the back of the pedestal sink will match up with the supply lines.

The technique for doing this will vary depending on the type of floor. For more on plumbing visit. Distance right to left from each water supply pipe to the drain. While the wall is open install blocking a horizontal 2x that s screwed between the studs at basin height beneath the palster or drywall.

For drilling into concrete use a hammer drill and a concrete bit.